Continuing our belief to stock and sell quality tested certified products, our hot water cylinder range is supplied by Gledhill, England, a manufacturer of quality hot water cylinders and storage tanks for domestic, commercial and industrial applications.

• Gledhill Stainless Lite unvented indirect cylinders are constructed of the very latest high specification Duplex stainless steel, resisting all forms of corrosion including crevice and stress, whilst providing high mechanical strength for long life
• Stainless Lite uses a high heat transfer corrugated tube heat exchanger giving a 20% faster recovery rate than plain tube exchangers
• Importantly for installers, the cylinders are particularly light and easy to handle on site
• A unique Gledhill diffuser reduces turbulence when cold water enters the cylinder allowing stratification of the heated water
• Minimum heat loss: tests show that the 50mm of polyurethane foam injected into the case and covering both domes achieves astonishingly low levels of heat loss

The Gledhill Stainless Lite is supplied complete with all the quality fittings you need

• Immersion heater
• Inlet control set
• 2 part zone valve
• Benchmark Log Book
• Wiring centre
• 15mm/22mm tundish
• Dual thermostat
• Expansion vessel with flexible hose and wall mounting bracket
• Full installation/maintenance instructions
• Temperature and pressure relief valve

Each indirect Stainless Lite cylinder has two coils, one for a conventional oil or gas fired boiler and another high performance coil for solar use, and an electrical immersion heater for back-up.